Diy outdoor projector screen1/21/2024 This not only makes for more efficient work, but our cuts will be more precise too. Next we cut the 2×12 rafters to length and clamped them all together so that we could cut the notches all at the same time. Whichever circular saw you’re using, make sure it’s big enough to make these deep cuts. Then we just popped out the slivers and cleaned up the cuts with a chisel. We measured and made our marks, spacing the notches out evenly across the length of the boards and used a handheld circular saw to make multiple cuts. We clamped the beams together so that when we make our cuts, the notches will line up. I like how this design has notches in both the beams and the rafters so everything should fit together like a puzzle. We first cut them to length with my track saw and then started cutting the notches. For the beams, we used a couple of 16-foot 2×12 boards. While the concrete cured, we got to work on cutting out the pergola parts. We used pressure treated lumber for this project and it normally wouldn’t be that expensive, but because lumber prices are absolutely absurd these days, we ended up paying around $600 for the lumber (ouch!). The faces of the 6圆s were parallel so that when we attach the beams overhead, everything will lay flat and even. When setting the posts, we had to make sure that they were both facing the same way – meaning, one wasn’t twisting in a different direction. Then we gave the concrete a few days to cure. I’m not sure if it did, but either way, it worked. You could also mix the concrete in a wheelbarrow, which we’ve done before, but we figured this way might save us some time. We poured dry concrete mix down into the hole and added some water and mixed it around until it was a peanut butter consistency. Then we used some scrap 2x4s and stakes to brace the posts in place so we could pour the concrete. Next, we dropped the posts down into the hole and used a level to make sure it was level and plumb. Then he poured a little paver base down in the bottom and tamped it down. He dug down about 2 feet deep, making the hole about 10 inches in diameter. We borrowed an augur from our good friend Josh and Adam got to digging. Our hammock is 12 feet long, so we decided that the posts should be about 13 feet apart. We roughly mapped out the location of the 6×6 posts by laying the hammock down on the ground and kind of eye-balling things. It also generates a materials list, permit submittal pages, and dealer locator, so you can plan, design, gather materials, and get building. It takes all the guesswork out of it, ensuring that your structure is strong, safe, and sound. Simpson Strong-Tie has recently created a free, web-based pergola planning software that allows you to design and customize your dream pergola or pavilion. Simpson Strong-Tie’s Pergola Planner Software Depending on your local codes, you may need to acquire a permit to build a structure like this one. The utility companies came out, flagged where the cables were, which is nowhere near where we’ll be digging, so we’re in the clear. The first thing we had to do was call 811 to make sure there were no utility lines or cables running underground, where we would need to dig to set the posts.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |